1179 bufTm is not named consistently
- Created
- 21 Oct 2013
- Status
- Not ApplicableClosed: the issue falls outside the scope of the standard. No further comments are taken. Show the workflow
- Part
- Part 7-2 (2010; Edition 2)
- Links
- None
- Page
- 192 DIN EN 61850-7-2
- Clause
- Annex B.2
- Paragraph
- Category
- No impact on this part
Issue
The attribute bufTm is defined by the CDC as "bufTm" whereas it is defined as "bufTime" in the XML-Schema (xsd). 61850-6, Table 23 even refers to 7-2, but in 7-2 the attribute is called "bufTm", not "bufTime".
Proposal
Either rename "bufTime" in 61850-6's schema to "bufTm", or rename "bufTm" in 61850-7-2 to "bufTime".
Another (probably easier) alternative would be to clearly point out that both attribute are meant to be the same. Ideally both documents should refer to each other with a remark.
| Discussion | Created |
|---|---|
|
Not Applicable
Part 6 define in Table 23: bufTime - Buffer time - see IEC 61850-7-2; default 0.
Part 7-2 defines the attribute of the report control block in 17.2.2.9 - BufTm - buffer time. I agree that the relation should be clear. |
29 Nov 13 |
| Discussion (red) Both, the RCB property bufTm and the SCL parameter bufTime refer to the definition in 7-2 under the header 'buffer time'. Thus the relation should be clear. | 24 Oct 13 |